Monday, 22 July 2013

Making BOOTABLE pendrive using CMD


 

Lots of people face the problems of Format/reinstall Windows. they have two choices are optical disk(DVD) or USB Pendrive. In the ultra book or latest new notbook have not DVD drive.Therefore if you wish to install windows you have to choose the other option, i.e. USB Pendrive. So here i give you Step by step 100% working tutorial on "create a windows 7 or 8 Bootable Pendrive" or "How to install Windows 7/8 from USB Pendrive".

Lets Start..
1) Run command prompt(cmd). this will be done by clicking start and typing cmd in Windows 7/Windows Xp, click on start and then click on run. Type cmd and run. This may Open the command prompt which is able to appear as if this:

 


 



2) Then run diskpart utility from CMD, by typing “diskpart” on command prompt and pressing enter. this will run the diskpart utility in a very separate windows, that is shown in image below: 

 

 



3) Now insert USB pendrive in any USB port. Remember that Your pen drive should be atleast 4 GB, 8 GB USB pendrive is best for This purpose. Now return to the diskpart console & type “listdisk” and press enter. this may list the different storage devices available. You’ll see the size column of the disk and here ‘disk 2′ is our pen drive. Warning: In your PC it may be some other number. In our case it’s “disk 2″. 

 

 4) Then you’ve got to type “select disk 2″ and press enter. Note: in our case it’s disk 2, in your case it may be disk 3/disk 1 or any different number. you can enter “detail disk” to check the details of the disk once you select it to verify that you’ve choosen the right disk. you’ll be able to see these steps within the image below:

  

5) Then you’ve to run a Series of commands. The commands to be run within the order are:
- clean
- create partition primary
- select partition 1
- active
- format fs=fat32
These steps are shown in the following Image:

  6) The format step can take some time.after the format is complete you’ve to run “assign” command. and after this U can exit diskpart utility by entering the “exit” command. The steps are shown below:
- assign
- exit

   In this image, all the steps taken from the 1st step:


7) when the format is complete, insert your original “Windows 7 DVD” in your DVD drive, or If you’ve an .iso image of the DVD, Mount that .iso image using “power ISO”(any virtual drive software). - Now open My Computer, and open the contents of DVD Drive.Select all contents and copy all the contents - Now open the USB Pendrive and press paste all the contents of DVD into the USB Disk. 
8 ) Once the copy finishes, you’re done simply remove the USB Pendrive safely and use it to install Windows 7 in your PC. 
Done .!njoy Guys. . . !!!


Reactions:

0 comments:

Post a Comment

 

Visitors Info.

You are from
%%v_FLG%% %%v_IP%%
%%v_CR%% ,%%v_RG%%, %%v_CI%%
%%v_OS_IMG%% %%v_OS%%
%%v_BRW_IMG%% %%v_BRW%%
%%v_I_RESO%% %%v_RESO%% %%v_I_CLR%% %%v_CLR%%
DMCA.com
hackerkonka.blogspot.in Webutation Creative Commons License
Hacker Konka by Konka Karthik is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 Unported License.
Back To Top